386/ix, Orchid, 1024x768

[carroll at m.cs.uiuc.edu]

Setup: Logix 25 Mhz '386, 16 Meg, 386/ix 2.0.2, X11R3 Development set.

Has anyone gotten X to work the an Orchid board in 1024x768 mode? I have
an Orchid ProDesigner+ w/512K, and when I try to run in 1024x768, the display
drips pixels all over. It looks a lot like a bank select problem - e.g., if
the cursor is on the lower part of the screen, pixels are dripped at vertical
locations above it. I've tested the board using FRACTINT, and it worked fine.

Also, has anyone managed to get the server development kit out of ISC? My
vendor told me I had to call ISC direct, and they told me I had to call
a particular person, who hasn't returned my call. Is there anypoint in
pursuing this, or is it a dead-end? Thanks!

Alan M. Carroll                "Like the north wind whistling down the sky,
carroll at cs.uiuc.edu             I've got a song, I've got a song.
Conversation Builder:           I carry it with me and I sing it loud
+ Tomorrow's Tools Today +      If it gets me nowhere, I'll go there proud"
Epoch Development Team          
CS Grad / U of Ill @ Urbana    ...{ucbvax,pur-ee,convex}!cs.uiuc.edu!carroll