Upgrade from 3.0 to 3.1 fails
George Robbins
grr at cbmvax.commodore.com
Tue Mar 27 11:15:27 AEST 1990
In article <2348 at husc6.harvard.edu> kovar at popvax.harvard.edu (David C. Kovar) writes:
>
> About a month ago I was upgrading two Vax 8250's from Ultrix 3.0 to 3.1.
>
> I rebooted the Vax off of the 3.0 disk and it came up correctly. I then
> attempted to install 3.1 over 3.0. The BASE installation failed with
> an error message that indicated that the 3.0 BASE was not installed correctly.
I'd suggest starting with a setld -i on each machine then doing a diff to
see what's different about the 3.0 modules loaded. If that doesn't make it
obvoius, try the install again as "sh -x setld ..." using tee or script to
save the output, then try to see exactly what it's objecting too.
Unless it's something obvious, you'll probably end up reinstalling 3.0 or
perhaps you could simply duplicate the working 3.1 system...
--
George Robbins - now working for, uucp: {uunet|pyramid|rutgers}!cbmvax!grr
but no way officially representing: domain: grr at cbmvax.commodore.com
Commodore, Engineering Department phone: 215-431-9349 (only by moonlite)
More information about the Comp.unix.ultrix
mailing list