SCO cu flow control

[Michael Mitchell]

I am trying to set up dial-in/dial-out capability on SCO
Xenix 386 2.3.2 with an error-correcting modem (Multi-tech
2400EH).  Ideally, I would like to use RTS/CTS flow control.
Dialing into the Xenix box works fine ... good flow control,
stty shows the expected rtsflow & ctsflow.  The problem is
the dial-out side with cu.  The flow control isn't active.
I would appreciate any ideas to correct this problem.

Michael V. Mitchell
al232 at cleveland.Freenet.Edu
michael at railnet.nshore.ncoast.org