IRQ 2 and tape drives

[Bob Willey]

Subject: Re: archive tape drives, xenix, how to setup
References: <135 at wyn386.UUCP>
Reply-To: bob at consult.UUCP (Bob Willey)
In article <135 at wyn386.UUCP> danielw at wyn386.UUCP (Daniel Wynalda) writes:
>I have an archive tape drive controller and archive tape drive (60MB drive)
>IRQ 2 on the jumper and for the installation of the tape drive.  For TYPE


Your problem is probably in the mkdev tape, you should specify the
IRQ as 25 and everything should be fine.  IRQ 2 is a special interrupt and
must be defined differently to the mkdev routine.  Change the driver to 25
and give it a shot, leaving the hardware the same, and you should be cooking.

Give this a try.
-- 
.. Computer Consulting Service     ..      Bob Willey        ..
.. P.O. Drawer 1690                ..    uunet!consult!bob   ..
.. Easton, Maryland  21601         ..    (301) 820-4670      ..
...............................................................