graphics on a Star Gemini 15-X printer from a 3b1

[Lenny Tropiano]

In article <494 at ntvax.UUCP> canoaf at ntvax.UUCP (Augustine Cano) writes:
|>I'm using a Star Micronics Gemini 15-X printer with my 3b1.
|>It works fine for normal printing, but being a non-supported printer,
|>I can't do anything fancy.  I have the system set up so it thinks it is a
|>StarSG10....
|>
|>If I do a <SHIFT> <PRINT> the screen gets actually printed, but in stripes.
|>The printer does not seem to understand the codes sent to move the paper up
|>less than the usual amount.
|>

Probably the easiest thing to do, if the Star Gemini 15-X is like my Star NX10,
is to set your printer up as an "Epson" printer.  The Star NX10 by default
I believe is Epson compatible, you need to change a dip switch to enable
"Star" mode.  Probably best if left as Epson, since almost everything has
an Epson driver (including the screen dump) ...

-Lenny
-- 
Lenny Tropiano             ICUS Software Systems         [w] +1 (516) 589-7930
lenny at icus.islp.ny.us      Telex; 154232428 ICUS         [h] +1 (516) 968-8576
{ames,talcott,decuac,hombre,pacbell,sbcs}!icus!lenny     attmail!icus!lenny
        ICUS Software Systems -- PO Box 1; Islip Terrace, NY  11752